| Input | Operating Voltage | 198-264Vac 50Hz/60Hz |
| Rated Input Voltage | 220-240Vac 50Hz/60Hz | |
| DC Input Voltage range | 200-240Vdc | |
| Input Current | 0.17A Max. | |
| Input Inrush Current | <15A (Half current pulse width100μs) @230Vac | |
| Power factor(@230V100% load) | ≥ 0.95 | |
| Total harmonic distortion | Typical:15% (@230Vac, 100% load) | |
| Stand-by power | ≤0.5W (@230Vac when DALI turn off) | |
| Efficiency(@230Vac,100% load) | 86% | |
| Wiring Method | Wire cross section:0.5-2.5mm² | |
| Output | Operating mode | Constant Current |
| Load type | LED | |
| Ripple requirement (Flickering or Flickering-Free） | Flicker value: less than 5% for whole dimming range | |
| Start up time | <1s (@230Vac) | |
| No-load output voltage | 60V DC Max. | |
| Load output voltage range | 12-50V DC | |
| Full load output power | 30W Max. | |
| Load output current | 500-1000mA | |
| Constant current/voltage Precision | Constant Current Precision ±5% | |
| Wiring method | Wire cross section:0.75-1.5mm² | |
| Control Method | Primary PUSH Dimming | Primary PUSH dimming (Max. lead wire length：20m） |
| DALI Dimming | DALI dimming (Max. lead length：300m） | |
| Dimming range | 2-100% | |
| Exception Protection Requirements | Output over temperature protection | Yes, without self recovery function（Can be inquired） |
| Output short circuit protection | Yes, without self recovery function（Can be inquired） | |
| Operating Environment | Operating temperature/ humidity | -25℃~50℃ Humidity: 85% (Non-condensing) |
| Storage temperature/ humidity | -40℃~80℃, Humidity: 85% (Non-condensing) | |
| Max. case temp（Tc） | 85℃ | |
| Safety & EMC | EMC standard | EN55015 EN61547 EN61000-3-2 EN61000-3-3 |
| DALI protocol standard | IEC62386-101 / 102 / 207 DT6 | |
| Safety standard | EN61347-1 EN61347-2-13 | |
| Certification | CE | |
| Withstand voltage | 3750Vac, 5mA, 60s (Input “L N”- Output “SEC”) | |
| Others | Degrees of protection | IP20 |
| Type of protection | Class II | |
| Installation type | Independent installation | |
| Dimension | 154*63*28mm | |
| Packaging requirement | PE bag + white box + manual + partition + outer box (K=A) | |
| Weight | ||
| Life | 5 year @Ta full load | |
| Note: All parameters are tested at the input voltage of 230Vac and 25 degree environment unless specified. | ||
ON/OFF & Description of Dimming Operation
matters needing Attention
1) The LED string must be connected to the load before turning on the input power, otherwise the LED string may be damaged.
2) After the LED drive input is powered off, there will be a residual voltage at the output, which can be maintained for about 3 minutes.
3) Before setting the parameters of the driver, please make sure the driver is powered off.
